MM74HC393N Integrated Circuit Chip Dual 4-Bit Binary Counter integrated circuit ic

MM74HC393 Dual 4-Bit Binary Counter

General Description

The MM74HC393 counter circuits contain independent ripple carry counters and utilize advanced silicon-gate CMOS technology. The MM74HC393 contains two 4-bit ripple carry binary counters, which can be cascaded to create a single divide-by-256 counter

Each of the two 4-bit counters is incremented on the HIGHto-LOW transition (negative edge) of the clock input, and each has an independent clear input. When clear is set HIGH all four bits of each counter are set to a low level. This enables count truncation and allows the implementation of divide-by-N counter configurations.

Each of the counters outputs can drive 10 low power Schottky TTL equivalent loads. This counter is functionally as well as pin equivalent to the 74LS393. All inputs are protected from damage due to static discharge by diodes to V_CC and ground.

Features

■ Typical operating frequency: 50 MHz

■ Typical propagation delay: 13 ns (Ck to QA)

■ Wide operating supply voltage range: 2–6V

■ Low input current: <1 µA

■ Low quiescent supply current: 80 µA maximum (74HC Series)

■ Fanout of 10 LS-TTL loads

Connection Diagram

Absolute Maximum Ratings

(Note 2)

(Note 1)

Supply Voltage (V_CC) −0.5 to +7.0V

DC Input Voltage (V_IN) −1.5 to V_CC +1.5V

DC Output Voltage (V_OUT) −0.5 to V_CC +0.5V

Clamp Diode Current (I_IK, I_OK) ±20 mA

DC Output Current, per pin (I_OUT) ±25 mA

DC V_CC or GND Current, per pin (I_CC) ±50 mA

Storage Temperature Range (T_STG) −65°C to +150°C

Power Dissipation (P_D) (Note 3) 600 mW

S.O. Package only 500 mW

Lead Temperature (T_L) (Soldering 10 seconds) 260°C

Note 1: Absolute Maximum Ratings are those values beyond which damage to the device may occur.

Note 2: Unless otherwise specified all voltages are referenced to ground.

Note 3: Power Dissipation temperature derating — plastic “N” package: − 12 mW/°C from 65°C to 85°C.

Stock Offer (Hot Sell)